2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL VALVE STEM OIL SEAL

HINT:
The intake valve stem oil seal is light brown and the exhaust valve stem oil seal is gray.

  1. A094934E06
    Apply a light coat of engine oil to the valve stem oil seal.

  1. A075639E01
    Using SST, push in a new valve stem oil seal.
    SST
    09201-41020  


2. INSTALL VALVE SPRING SEAT

  1. A075638E01
    Install the valve spring seat.


3. INSTALL VALVE

  1. A075640E02
    Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.

  1. A075602E03
    Place the cylinder head on wooden blocks.

  1. Install the valve, inner compression spring and valve spring retainer to the cylinder head.

    NOTICE:
    Install the same parts in the same combination to their original locations.

  1. Using SST, compress the inner compression spring and place the valve spring retainer lock around the valve stem.

    SST
    09202-70020   (09202-00010)

  1. A075641E01
    Using a pin punch 5 and hummer, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.


4. INSTALL VALVE LIFTER

  1. A075601E01
    Apply engine oil to the valve stem end and valve lifter, and install the valve lifter to the valve stem.

  1. Check that the valve lifter rotates smoothly by hand.

← REPLACEMENT (from Jan 2012)REASSEMBLY (from Jan 2012) →