Removal / installation · Vehicles built Sep 2011 – Dec 2011
HINT:
If the thermostat is not installed, cooling efficiency decreases. Do not remove the thermostat as this will cause the engine to overheat easily.
1.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.
2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
3.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Remove the 10 bolts and No. 1 engine under cover.
4.
DRAIN ENGINE COOLANT
CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant.
HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.
Torque:
13 N*m{
130 kgf*cm
, 9 ft.*lbf
}
Tighten the radiator drain cock plug by hand.
5.
REMOVE V-BANK COVER SUB-ASSEMBLY
Remove the 2 nuts and V-bank cover.
6.
REMOVE AIR CLEANER HOSE ASSEMBLY
Disconnect the vacuum transmitting hose and No. 2 ventilation hose.
Loosen the 2 hose clamps.
Remove the air cleaner hose.
7.
DISCONNECT WATER INLET
Remove the 3 nuts, and disconnect the water inlet from the water inlet housing.