2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL FAN & GENERATOR V BELT

  1. A163771E05
    Set the V belt onto every part.

  1. While turning the belt tensioner counterclockwise, remove the bar.

    Text in Illustration 
    *1
    Vane Pump
    *2
    Water Pump
    *3
    No. 1 Idler
    *4
    Fan
    *5
    Generator
    *6
    Belt Tensioner
    *7
    Crankshaft
    *8
    Cooler Compressor

    NOTICE:
    Make sure that the V belt is properly set to each pulley.

  1. B000540E14
    After installing the belt, check that it fits properly in the ribbed grooves.
    Text in Illustration 
    *a
    CORRECT
    *b
    INCORRECT

    HINT:
    Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.


2. INSTALL V-BANK COVER SUB-ASSEMBLY

  1. A177597E02
    Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.
    Text in Illustration 
    *1
    Bracket
    *2
    Hook
    *3
    Pin
    *4
    Grommet


3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the No. 1 engine under cover with the 10 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
  1. Push in the clip to install the front fender splash shield sub-assembly LH.

  1. Install the 3 bolts and screw.


5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
  1. Push in the clip to install the front fender splash shield sub-assembly RH.

  1. Install the 3 bolts and 2 screws.

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →