Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
1.
INSTALL FAN & GENERATOR V BELT
Set the V belt onto every part.
While turning the belt tensioner counterclockwise, remove the bar.
Text in Illustration
*1
Vane Pump
*2
Water Pump
*3
No. 1 Idler
*4
Fan
*5
Generator
*6
Belt Tensioner
*7
Crankshaft
*8
Cooler Compressor
NOTICE:
Make sure that the V belt is properly set to each pulley.
After installing the belt, check that it fits properly in the ribbed grooves.
Text in Illustration
*a
CORRECT
*b
INCORRECT
HINT:
Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
2.
INSTALL V-BANK COVER SUB-ASSEMBLY
Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.
Text in Illustration
*1
Bracket
*2
Hook
*3
Pin
*4
Grommet
3.
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Install the No. 1 engine under cover with the 10 bolts.
Torque:
29 N*m{
296 kgf*cm
, 21 ft.*lbf
}
4.
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Push in the clip indicated by the arrow in the illustration to install the fender splash shield.
Install the 3 bolts and screw.
5.
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.