1.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
Remove the 3 bolts and screw.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.
2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
Remove the 3 bolts and 2 screws.
Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.
3.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
Remove the 10 bolts and No. 1 engine under cover.
4.
REMOVE V-BANK COVER SUB-ASSEMBLY
Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
Text in Illustration
*1
Bracket
*2
Hook
*3
Pin
*4
Grommet
5.
REMOVE FAN & GENERATOR V BELT
While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
Text in Illustration
*1
Bar
HINT:
The pulley bolt for the belt tensioner has a left-hand thread.