2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
  1. Remove the automatic transmission (Click here).


3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A176499E01
    Using SST, hold the crankshaft damper.
    SST
    09213-70011   (09213-70020)
    09330-00021   (09330-00030)

  1. A160778
    Remove the 8 bolts, front drive plate spacer, drive plate and rear drive plate spacer.


4. REMOVE ENGINE REAR OIL SEAL

  1. A160779E01
    Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.

← COMPONENTS (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →