2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012


1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)

2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

  1. A218920E01
    Using SST, hold the crankshaft.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. A228359
    Remove the 10 bolts, the rear drive plate spacer, the drive plate and ring gear, and the crankshaft angle sensor rotor.


3. REMOVE REAR CRANKSHAFT OIL SEAL

  1. A228391E01
    Using a knife, cut off the lip of the rear crankshaft oil seal.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Cut Position

  1. Using a screwdriver, pry out the rear crankshaft oil seal.

    NOTICE:
    Do not damage the surface of the rear crankshaft oil seal press fit hole or crankshaft.

    HINT:
    Tape the screwdriver tip before use.

← COMPONENTS (from Jan 2012)INSTALLATION (from Jan 2012) →