2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter yoke.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. A115022
    Place the brush holder on the starter yoke.

  1. Using a screwdriver, hold the brush spring back.

  1. Connect the brush to the brush holder.

  1. Connect the 4 brushes.

    NOTICE:
    Check that the positive (+) lead wires are not grounded.

  1. A164441E01
    Install 2 new O-rings and the starter commutator end cover with the 2 screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 34 in.*lbf }

  1. Install the dust protector as shown in the illustration.


3. INSTALL STARTER CLUTCH SUB-ASSEMBLY

  1. A161550E01
    Apply grease to the steel ball, return spring, clutch roller, retainer and idler gear.

  1. Install the steel ball.

  1. Install a new O-ring to the starter housing.

  1. Insert the return spring into the magnet starter switch hole.

  1. Install the starter clutch, idler gear, retainer and clutch roller.

  1. A164440E01
    Install the starter housing to the magnet starter switch with the 2 screws.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Install the dust protector as shown in the illustration.


4. INSTALL STARTER YOKE ASSEMBLY

  1. B012328E01
    Install a new O-ring to the groove of the starter yoke.

  1. Align the protrusion of the starter yoke with the groove of the magnet starter switch.

  1. A159744
    Install the starter yoke with the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to the magnet starter switch terminal with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →