2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit is used when an incoming cellular phone voice in the "Bluetooth" handsfree system is received.

WIRING DIAGRAM

E194168E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)
  1. Disconnect the F19 radio receiver assembly and F18 stereo component amplifier assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F19-11 (IVO+) - F18-15 (II1+)
    Always
    Below 1 Ω
    F19-12 (IVO-) - F18-14 (II1-)
    Always
    Below 1 Ω
    F19-11 (IVO+) - Body ground
    Always
    10 kΩ or higher
    F19-12 (IVO-) - Body ground
    Always
    10 kΩ or higher
    F19-13 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter (from Jan 2012)Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier (from Jan 2012) →