Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit is used when an incoming cellular phone voice in the "Bluetooth" handsfree system is received.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER) |
Disconnect the F19 radio receiver assembly and F18 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F19-11 (IVO+) - F18-15 (II1+)
Always
Below 1 Ω
F19-12 (IVO-) - F18-14 (II1-)
Always
Below 1 Ω
F19-11 (IVO+) - Body ground
Always
10 kΩ or higher
F19-12 (IVO-) - Body ground
Always
10 kΩ or higher
F19-13 (SLD1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
