REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2. REMOVE V-BANK COVER SUB-ASSEMBLY |
Remove the 2 nuts and V-bank cover.

| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
Disconnect the vacuum transmitting hose and No. 2 ventilation hose.

Loosen the 2 hose clamps.
Remove the air cleaner hose.
| 4. REMOVE AIR CLEANER ASSEMBLY |
Disconnect the clamp and MAF connector.

Remove the 3 bolts and air cleaner.
| 5. REMOVE FAN & GENERATOR V BELT |
Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

- HINT:
- The pulley bolt for the belt tensioner has left-hand thread.
| 6. DRAIN POWER STEERING FLUID |
| 7. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE |
![]() ![]() |
Slide the clip and disconnect the hose from the vane pump.
| 8. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR |
![]() ![]() |
Disconnect the connector.
| 9. DISCONNECT PRESSURE FEED TUBE |
Remove the union bolt and disconnect the pressure feed tube.

Remove the gasket.
| 10. REMOVE VANE PUMP ASSEMBLY |
![]() ![]() |
Remove the 2 bolts, nut and vane pump.



