2011-2013 Land Cruiser · Service Manual Steering

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. FIX VANE PUMP ASSEMBLY

  1. C158820E01
    Using SST, fix the vane pump in a vise.
    SST
    09630-00014   (09631-00132)


2. REMOVE POWER STEERING SUCTION PORT UNION

C158821
  1. Remove the bolt and suction port union from the vane pump.

  1. Using a screwdriver, remove the O-ring from the suction port union.


3. REMOVE FLOW CONTROL VALVE

C158958
  1. Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and compression spring.


4. REMOVE VANE PUMP REAR HOUSING

  1. C131230
    Remove the 4 bolts and rear housing from the front housing.

  1. C107025E02
    Using a screwdriver, remove the O-ring from the rear housing.

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE VANE PUMP SHAFT WITH VANE PUMP PULLEY

  1. C131231
    Using 2 screwdrivers, remove the snap ring from the vane pump shaft.

  1. Remove the vane pump shaft with vane pump pulley.

    NOTICE:
    Be careful not to drop or damage the vane pump shaft with vane pump pulley. If it is damaged, replace the vane pump assembly.


6. REMOVE VANE PUMP ROTOR

C114697
  1. Remove the 10 vane pump plates.

    NOTICE:
    Take care not to drop the vane pump plate.

  1. Remove the vane pump rotor.


7. REMOVE VANE PUMP CAM RING

C114698
  1. Remove the cam ring from the front housing.


8. REMOVE VANE PUMP FRONT SIDE PLATE

C114699
  1. Remove the front side plate from the front housing.

  1. C107029E02
    Using a screwdriver, remove the O-ring from the front side plate.

    HINT:
    Tape the screwdriver tip before use.

  1. C114700
    Remove the O-ring from the front housing.


9. REMOVE VANE PUMP HOUSING OIL SEAL

C114701E02
  1. Using a screwdriver and piece of cloth, pry out the oil seal.

    NOTICE:
    Be careful not to damage the front housing.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →