DISASSEMBLY
Removal / installation · Vehicles built from Sep 2011
| 1.
FIX VANE PUMP ASSEMBLY |
 |
- Using SST, fix the vane pump in a vise.
- SST
- 09630-00014
(09631-00132)
| 2.
REMOVE POWER STEERING SUCTION PORT UNION |
 |
- Remove the bolt and suction port union from the vane pump.
Using a screwdriver, remove the O-ring from the suction port union.
| 3.
REMOVE FLOW CONTROL VALVE |
 |
- Remove the pressure port union.
Remove the O-ring from the pressure port union.
Remove the flow control valve and compression spring.
| 4.
REMOVE VANE PUMP REAR HOUSING |
 |
- Remove the 4 bolts and rear housing from the front housing.
- Using a screwdriver, remove the O-ring from the rear housing.
- HINT:
- Tape the screwdriver tip before use.
| 5.
REMOVE VANE PUMP SHAFT WITH VANE PUMP PULLEY |
 |
- Using 2 screwdrivers, remove the snap ring from the vane pump shaft.
Remove the vane pump shaft with vane pump pulley.
- NOTICE:
- Be careful not to drop or damage the vane pump shaft with vane pump pulley. If it is damaged, replace the vane pump assembly.
| 6.
REMOVE VANE PUMP ROTOR |
 |
- Remove the 10 vane pump plates.
- NOTICE:
- Take care not to drop the vane pump plate.
Remove the vane pump rotor.
| 7.
REMOVE VANE PUMP CAM RING |
 |
- Remove the cam ring from the front housing.
| 8.
REMOVE VANE PUMP FRONT SIDE PLATE |
 |
- Remove the front side plate from the front housing.
- Using a screwdriver, remove the O-ring from the front side plate.
- HINT:
- Tape the screwdriver tip before use.
- Remove the O-ring from the front housing.
| 9.
REMOVE VANE PUMP HOUSING OIL SEAL |
 |
- Using a screwdriver and piece of cloth, pry out the oil seal.
- NOTICE:
- Be careful not to damage the front housing.