2011-2013 Land Cruiser · Service Manual Steering

DISASSEMBLY

Removal / installation · Vehicles built from Jan 2012


1. FIX VANE PUMP ASSEMBLY

  1. C158820E01
    Using SST, fix the vane pump in a vise.
    SST
    09630-00014   (09631-00132)


2. REMOVE POWER STEERING SUCTION PORT UNION

  1. C158821
    Remove the bolt and suction port union from the vane pump.

  1. Using a screwdriver, remove the O-ring from the suction port union.


3. REMOVE FLOW CONTROL VALVE

  1. C228110
    Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and compression spring.


4. REMOVE VANE PUMP REAR HOUSING

  1. C131230
    Remove the 4 bolts and rear housing from the front housing.

  1. C107025E04
    Using a screwdriver, remove the O-ring from the rear housing.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE VANE PUMP SHAFT WITH VANE PUMP PULLEY

  1. C131231
    Using 2 screwdrivers, remove the snap ring from the vane pump shaft.

  1. Remove the vane pump shaft with vane pump pulley.

    NOTICE:
    Be careful not to drop or damage the vane pump shaft with vane pump pulley. If it is damaged, replace the vane pump assembly.


6. REMOVE VANE PUMP ROTOR

  1. C114697
    Remove the 10 vane pump plates.

    NOTICE:
    Take care not to drop the vane pump plate.

  1. Remove the vane pump rotor.


7. REMOVE VANE PUMP CAM RING

  1. C114698
    Remove the cam ring from the front housing.


8. REMOVE VANE PUMP FRONT SIDE PLATE

  1. C114699
    Remove the front side plate from the front housing.

  1. C107029E04
    Using a screwdriver, remove the O-ring from the front side plate.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.

  1. C114700
    Remove the O-ring from the front housing.


9. REMOVE VANE PUMP HOUSING OIL SEAL

  1. C114701E04
    Using a screwdriver and piece of cloth, pry out the oil seal.
    Text in Illustration 
    *1
    Cloth

    NOTICE:
    Be careful not to damage the front housing.

← REMOVAL (from Jan 2012)INSPECTION (from Jan 2012) →