2011-2013 Land Cruiser · Service Manual Steering

REMOVAL

Removal / installation · Vehicles built from Jan 2012


1. PRECAUTION

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT WHEEL RH

4. REMOVE FRONT FENDER APRON TRIM PACKING A

  1. B310792
    Remove the 3 bolts and 2 screws.

  1. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.


5. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A274415E01
    Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
    Text in Illustration 
    *1
    Grommet
    *2
    Pin
    *3
    Hook
    *4
    Bracket


6. REMOVE AIR CLEANER AND HOSE

  1. A271401
    Disconnect the No. 2 PCV hose and No. 1 air hose.

  1. Disconnect the mass air flow meter connector and detach the clamp.

  1. Remove the 3 bolts and loosen the hose clamp, and then remove the air cleaner and hose.


7. REMOVE FAN AND GENERATOR V BELT

  1. A163770E04
    While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar with a diameter of 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
    Text in Illustration 
    *1
    Bar
    *2
    Service Hole
    *a
    Turn

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the fan and generator V belt.


8. DRAIN POWER STEERING FLUID

9. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR

  1. C172783
    Detach the wire harness clamp and disconnect the connector.


10. DISCONNECT PRESSURE FEED TUBE

  1. C172781E03
    Remove the bolt and disconnect the pressure feed tube.
    Text in Illustration 
    *1
    Pressure Feed Tube

  1. Remove the gasket.


11. DISCONNECT SUCTION HOSE

  1. C172782
    Slide the clip and disconnect the suction hose from the vane pump.


12. REMOVE VANE PUMP ASSEMBLY

  1. C161012
    Remove the 2 bolts and vane pump.

← COMPONENTS (from Jan 2012)DISASSEMBLY (from Jan 2012) →