2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY

  1. A159726
    Apply a light coat of gasoline to a new O-ring, and install it to the pressure regulator.

  1. While turning the pressure regulator to the left and right, install it to the delivery pipe.

  1. A159711
    Install the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the fuel return hose to the pressure regulator.

  1. A159710
    Connect the vacuum transmitting hose to the pressure regulator.


2. INSTALL VACUUM CONTROL VALVE SET (w/ Secondary Air Injection System)

  1. A179568
    Install the vacuum control valve set with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the 3 vacuum hoses.

  1. Connect the 2 VSV connectors.


3. INSTALL V-BANK COVER SUB-ASSEMBLY

  1. A178997
    Attach the 2 V-bank cover hooks to the bracket.

  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


5. INSPECT FOR FUEL LEAK
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG) and intelligent tester ON.

    NOTICE:
    Do not start the engine.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the Fuel Pump Speed Control.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.

← REMOVAL (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →