2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.


1. REMOVE NO. 2 ENGINE UNDER COVER

  1. A178462
    Remove the 2 bolts and No. 2 engine under cover.


2. REMOVE TAILPIPE ASSEMBLY
  1. Remove the bolt, clamp and gasket.

  1. Remove the tailpipe from the 2 exhaust pipe supports.


3. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 4 bolts.

  1. Remove the center exhaust pipe from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.


4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 3 nuts, front No. 2 exhaust pipe and gasket.


5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Detach the heated oxygen sensor wire clamp.

  1. Remove the 3 nuts, front exhaust pipe and gasket.


6. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

  1. A168889E01
    Using SST, remove the sensor.
    SST
    09224-00010  


7. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

  1. A168889E01
    Using SST, remove the sensor.
    SST
    09224-00010  


8. REMOVE NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

  1. A158664E01
    Using SST, remove the sensor.
    SST
    09224-00010  


9. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

  1. A158664E01
    Using SST, remove the sensor.
    SST
    09224-00010  

← COMPONENTS (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →