2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Sep 2011

CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.


1. REMOVE NO. 2 ENGINE UNDER COVER

  1. A178462
    Remove the 2 bolts and No. 2 engine under cover.


2. REMOVE TAILPIPE ASSEMBLY
  1. Remove the bolt, clamp and gasket.

  1. Remove the tailpipe from the 2 exhaust pipe supports.

  1. Remove the bolt and clamp, and then disconnect the tailpipe from the center exhaust pipe.


3. REMOVE EXHAUST PIPE DAMPER

  1. A175001
    Remove the 2 bolts and exhaust pipe damper from the tailpipe.


4. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 4 bolts.

  1. Remove the center exhaust pipe from the 3 exhaust pipe supports.

  1. Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.


5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the bolt and disconnect the wire harness clamp bracket of the oxygen sensor from the transmission.

  1. Remove the 2 nuts, front No. 2 exhaust pipe and gasket from the exhaust manifold LH.


6. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the bolt and disconnect the wire harness clamp bracket of the oxygen sensor from the transmission.

  1. Remove the 2 nuts, front exhaust pipe and gasket from the exhaust manifold RH.


7. REMOVE NO. 2 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Using SST, remove the sensor.

    SST
    09224-00010  


8. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

  1. A158664E01
    Using SST, remove the sensor.
    SST
    09224-00010  

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →