REMOVAL
Removal / installation · Vehicles built from Jan 2012
| 1.
REMOVE V-BANK COVER SUB-ASSEMBLY
|
 |
- Raise the front of the V-bank cover to detach the 3 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
Text in Illustration
*1
|
Grommet
|
*2
|
Pin
|
*3
|
Hook
|
*4
|
Bracket
|
| 2.
REMOVE AIR CLEANER AND HOSE |
 |
- Disconnect the No. 2 PCV hose and No. 1 air hose.
Disconnect the mass air flow meter connector and detach the clamp.
Remove the 3 bolts and loosen the hose clamp, and then remove the air cleaner and hose.
| 3.
REMOVE IGNITION COIL ASSEMBLY |
 |
for Bank 1:
- Detach the 4 clamps and disconnect the engine wire.
Disconnect the 4 ignition coil connectors.
- Remove the 4 bolts and 4 ignition coils.
for Bank 2:
- Remove the 2 bolts and disconnect the water by-pass pipe.
- Detach the 3 clamps and disconnect the engine wire.
Disconnect the 4 ignition coil connectors.
- Remove the 4 bolts and 4 ignition coils.
| 4.
REMOVE SPARK PLUG |
 |
Using a 16 mm plug wrench, remove the 8 spark plugs.