2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011


INSPECT INTAKE AIR CONTROL VALVE

A133683
  1. Apply 40 kPa (300 mmHg, 11.8 in.Hg) of vacuum to the actuator and check that the actuator rod moves.

  1. One minute after applying vacuum in the above step, check that the actuator rod does not return.
    If the result is not as specified, replace the intake manifold.


INSPECT VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

  1. A085583E09
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    33 to 39 Ω
    1 - Body ground
    Always
    1 MΩ or higher
    2 - Body ground

    If the result is not as specified, replace the vacuum switching valve assembly.

  1. Check the VSV operation.

    1. B002276E01
      Check that air flows from port E to the filter.

    2. B002277E01
      Apply battery voltage to the connector, and check the VSV operation.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Check that air flows from port E to F

      If the result is not as specified, replace the vacuum switching valve assembly.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →