2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P0604 Random Access Memory (RAM)

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

The ECM continuously monitors its internal memory status. This self-check ensures that the ECM is functioning properly. The ECM memory status is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect Random Access Memory (RAM) errors. If outputs from these CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTC immediately.
DTC No.
DTC Detection Condition
Trouble Area
P0604
ECM RAM errors (Main CPU and sub CPU mirroring failure) (1 trip detection logic).
ECM

CONFIRMATION DRIVING PATTERN

  1. Turn the engine switch off.
  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) battery terminal.
  4. Turn the engine switch on (IG) and wait for 16 seconds or more.

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Clear DTCs (Click here).

  1. Turn the GTS off.

  1. Turn the engine switch off.

  1. Disconnect the GTS.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG) and turn the GTS on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Check for DTCs.

    OK:
    P0604 is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P0560 System Voltage (from Jan 2012)P0606 ECM / PCM Processor (from Jan 2012) →