2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.

HINT:
When a particular warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in the relevant ECU is suspected.


WIRING DIAGRAM

E158854E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

  1. E158855E05
    Disconnect the A38*1 or A52*2 ECM connector.
    1. *1: for LHD
    2. *2: for RHD

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    E22-13 (TC) - A38-16 (TC)
    Always
    Below 1 Ω
    E22-4 (CG) - Body ground
    E22-13 (TC) - Body ground
    Always
    10 kΩ or higher
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    E22-13 (TC) - A52-16 (TC)
    Always
    Below 1 Ω
    E22-4 (CG) - Body ground
    E22-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cruise SET Indicator Light Circuit (from Jan 2012)COMPONENTS (from Sep 2011) →