2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

Cruise SET Indicator Light Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

  1. When the ECM detects a cruise control switch on signal from the cruise control switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control SET indicator light turns on.
  2. The cruise control SET indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE CONTROL SET INDICATOR)
  1. Select the item below in the Active Test, and then check that the cruise control SET indicator light illuminates (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. SET
    Cruise control SET indicator light
    ON / OFF
    -

    OK:
    Cruise control SET indicator light turns on/off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL SET INDICATOR)
  1. Use the Data List to check if the cruise control switch is functioning properly (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    SET/COAST Switch
    -SET switch signal / ON or OFF
    ON: -SET switch on
    OFF: -SET switch off
    -

    OK:
    On screen, item changes between ON and OFF according to above chart.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1UR-FE)
    B
    NG (for 3UR-FE)
    C



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)
A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cruise Main Indicator Light Circuit (from Jan 2012)TC and CG Terminal Circuit (from Jan 2012) →