2011-2013 Land Cruiser · Service Manual Vehicle Interior

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Sep 2011


LIST OF OPERATION METHODS
By operating each of the air conditioning control switches as shown in the diagram below, it is possible to enter the diagnostic check mode.

HINT:
  1. Use the same procedures for the LHD vehicle and RHD vehicle.
  2. The procedures listed below are for the LHD vehicle.

E140264E08

INDICATOR CHECK
E157037E02
  1. Turn the engine switch off.

  2. Turn the engine switch on (ACC) and wait at least 5 seconds.

    HINT:
    Vehicle with Navigation System only.

  3. Turn the engine switch on (IG) while pressing the A/ C control panel "AUTO" switch and "Recirculation/ Fresh" switch simultaneously.
    Hold both switches until the indicator check screen appears.

    Text in Illustration 
    *A
    w/ Navigation System
    *B
    w/o Navigation System

  4. E106865E06
    Check that all indicators turn on and off 4 times in succession at 1 second intervals.

    HINT:
    1. After the indicator check is completed, the system enters the DTC mode automatically.
    2. Press the "Off" switch to cancel the indicator check.

← DTC CHECK / CLEAR (from Sep 2011)DATA LIST / ACTIVE TEST (from Sep 2011) →