2011-2013 Land Cruiser · Service Manual Vehicle Interior

Back-up Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when turning the engine switch off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E160327E03

INSPECTION PROCEDURE


1. INSPECT FUSE (A/C)
  1. Remove the A/C fuse from the cowl side junction block LH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A/C fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)
E157362E05
  1. w/ Rear Heater

    1. Disconnect the E36 amplifier connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      E36-6 (+B1) - Body ground
      Always
      11 to 14 V
      E36-7 (+B2) - Body ground

  1. E160300E06
    w/o Rear Heater
    1. Disconnect the E81amplifier connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      E81-21 (+B1) - Body ground
      Always
      11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)


← Back-up Power Source Circuit (Sep 2011 – Dec 2011)PRECAUTION (from Sep 2011) →