2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

  1. B178616
    Detach the bracket claw and remove the bracket.

  1. B178617
    Remove the 2 bolts, room light bracket and drive gear.


2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

B178621E01
  1. Remove the 2 screws.

  1. Detach the 4 claws and remove the sliding roof piece LH and RH.

  1. Slide and remove the trim.


3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH

  1. B178631
    Remove the stopper.


4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH

HINT:
Use the same procedures described for the LH side.


5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.

  1. B178622
    Remove the 2 screws and 2 stoppers.

  1. B178623E01
    Using a screwdriver, detach the 2 claws slide the rear roof drip channel rearward to remove it.

    HINT:
    Tape the screwdriver tip before use.

  1. B178618
    Hold down the window deflector.

  1. B178626E01
    Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.

  1. B178619E01
    Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (from Jan 2012)REASSEMBLY (from Sep 2011) →