2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

  1. Hold down the window deflector.

    NOTICE:
    B178620
    Make sure that the spring indicated by the arrow in the illustration is securely installed.

  1. B178624E01
    Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.

    HINT:
    Tape the screwdriver tip before use.

  1. B178625E01
    Slide the rear roof drip channel forward and attach the 2 claws to install it.

  1. B178622
    Install the 2 stoppers with the 2 screws.


2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

B178626E02
  1. Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.

    HINT:
    Tape the screwdriver tip before use.


3. INSTALL SLIDING ROOF SUNSHADE STOPPER LH

  1. B178631
    Install the stopper.


4. INSTALL SLIDING ROOF SUNSHADE STOPPER RH

HINT:
Use the same procedures described for the LH side.


5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY

  1. B181118E01
    Insert the sunshade trim into the sliding roof housing.

  1. Attach the 4 claws to install the sliding roof piece LH and RH.

  1. Install the 2 screws.


6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

B178617
  1. Install the drive gear and room light bracket with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. B178616
    Attach the bracket claw to install the bracket.

← DISASSEMBLY (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →