2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

A Remote Control System does not Operate

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

INSPECTION PROCEDURE


1. CLEAN INFRARED RAY RECEIVING PORTION

  1. E192462
    Clean the infrared ray receiving portion on the television display assembly.

  1. Check whether the same malfunction occurs.

    OK:
    The function returns to normal.



NG
Go to step 2
OK

END

2. CHECK SYSTEM

  1. E182171E01
    Check that the remote control operation of the rear system is not locked by the multi-media module receiver assembly.
    1. Check if "Rear System Locked" appears on the television display.

      OK:
      The message does not appear.

      HINT:
      If the rear system is locked and the remote control is used in the rear seat area, an operation not possible message (for example, "Rear System Locked") is displayed. If the message is displayed, enter the multi-display assembly screen setting, and change "Rear System Lock" to Off.

      Text in Illustration 
      *1
      Television Display Assembly
      *2
      Multi-display Assembly



NG
RELEASE LOCK
OK


3. CHECK REMOTE CONTROL (BATTERY)
  1. Check that the dry-cell battery of the remote control is not depleted.

    OK:
    Battery is not depleted.



NG
REPLACE REMOTE CONTROL BATTERY
OK


4. REPLACE REMOTE CONTROL
  1. Replace the remote control with a new or known good one.

  1. Check that the remote control system operates normally.

    OK:
    The remote control system operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (REMOTE CONTROL WAS DEFECTIVE)


← A Remote Control System does not Operate (Sep 2011 – Dec 2011)Television Display does not Turn ON (Sep 2011 – Dec 2011) →