2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DATA LIST / ACTIVE TEST

System information · Vehicles built from Jan 2012


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch ON.

  5. Turn the intelligent tester on.

  6. Enter the following menus: Body / Main Body / Active Test.

  7. According to the display on the tester. perform the "Active Test".

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Head Light Cleaner
    Headlight low beam signal
    ON / OFF
    -

← TERMINALS OF ECU (from Jan 2012)COMPONENTS (Sep 2011 – Dec 2011) →