2011-2013 Land Cruiser · Service Manual Vehicle Exterior

TERMINALS OF ECU

System information · Vehicles built from Jan 2012


CHECK HEADLIGHT CLEANER CONTROL RELAY (w/ Headlight Cleaner System)
E139344

HINT:
The headlight cleaner control relay uses waterproof connector. Therefore, voltage cannot be checked with the connector connected to the vehicle.

Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
3 (IG) - 4 (E)
-
IG signal circuit
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
4 (E) - Body ground
-
Ground circuit
Always
Below 1 Ω
6 (PB) - 4 (E)
-
Headlight cleaner motor operation signal
Headlight cleaner motor is stopped
11 to 14 V
Headlight cleaner motor is operating
Below 1 V
2 (H) - 4 (E)
-
Headlight cleaner switch and headlight switch operation signal
Ignition switch ON
Headlight cleaner switch is off
Below 1 V
Ignition switch ON
Headlight switch is off
Below 1 V
Ignition switch ON
Headlight cleaner switch is on and headlight dimmer switch in HEAD
11 to 14 V
5 (FRWA) - 4 (E)*
-
Front washer switch operation signal
Ignition switch ON
Front washer switch is off
11 to 14 V
Ignition switch ON
Front washer switch is on
Below 1 V
1 (HDLO) - 4 (E)*
-
Headlight low beam operation signal
Ignition switch ON
Headlight dimmer switch in HEAD
11 to 14 V
Ignition switch ON
Headlight dimmer switch not in HEAD
Below 1 V
  1. *: w/ Headlight Auto Leveling
← PROBLEM SYMPTOMS TABLE (from Jan 2012)DATA LIST / ACTIVE TEST (from Jan 2012) →