2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)

  1. E156197E05
    Check the LO operation.

    1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1 (+1)
      Battery negative (-) → Terminal 5 (E)
      Motor operates at low speed

      If the result is not as specified, replace the windshield wiper motor assembly.

  1. Check the HI operation.

    1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 4 (+2)
      Battery negative (-) → Terminal 5 (E)
      Motor operates at high speed

      If the result is not as specified, replace the windshield wiper motor assembly.

  1. Check the automatic stop operation.

    1. Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 3 (+S) and 1 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    3. Check that the motor stops automatically at the automatic stop position.

      OK:
      Automatically stops.

      If the result is not as specified, replace the windshield wiper motor assembly.


INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)

  1. E156197E06
    Check the LO operation.

    1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 5 (+1)
      Battery negative (-) → Terminal 4 (E)
      Motor operates at low speed

      If the result is not as specified, replace the windshield wiper motor assembly.

  1. Check the HI operation.

    1. Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (+2)
      Battery negative (-) → Terminal 4 (E)
      Motor operates at high speed

      If the result is not as specified, replace the windshield wiper motor assembly.

  1. Check the automatic stop operation.

    1. Connect the positive (+) battery lead to terminal 5 (+1) of the connector and the negative (-) battery lead to terminal 4 (E). With the motor operating at low speed (LO), disconnect terminal 5 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

    2. Using SST, connect terminals 1 (+S) and 5 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

      SST
      09843-18040  

    3. Check that the motor stops automatically at the automatic stop position.

      OK:
      Automatically stops.

      If the result is not as specified, replace the windshield wiper motor assembly.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →