2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for LHD and RHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE UPPER RADIATOR SUPPORT SEAL

  1. Remove the 7 clips and radiator support seal.

    B180890E02


4. REMOVE FRONT FENDER MAIN SEAL LH

  1. B181061
    Using a clip remover, detach the 3 clips and remove the fender main seal.


5. REMOVE FRONT FENDER MAIN SEAL RH

HINT:
Use the same procedure described for the LH side.


6. REMOVE FRONT WIPER ARM LH
  1. Remove the nut, wiper arm and blade.


7. REMOVE FRONT WIPER ARM RH
  1. Remove the nut, wiper arm and blade.


8. REMOVE HOOD TO COWL TOP SEAL

  1. E156189
    Using a clip remover, detach the 12 clips, 4 clamps and remove the hood to cowl top seal.


9. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

  1. E156188
    Remove the washer hose.

  1. E156191
    Remove the 2 clips.

  1. Detach the 17 claws and remove the cowl top ventilator louver sub-assembly.


10. REMOVE WINDSHIELD WIPER LINK ASSEMBLY

  1. E156190E02
    Disconnect the connector. Then detach the clamp and remove the wire harness from the cowl top panel.

  1. Remove the 3 bolts and slide the link to disconnect the connection as shown in the illustration to remove the wiper link.


11. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

  1. E161961E01
    Detach the clamp and remove the wiper motor cover.

  1. E156193
    Using a screwdriver with the tip wrapped with protective tape, disconnect the rod of the windshield wiper link assembly from the crank arm pivot of the windshield wiper motor assembly as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. E156192
    Using a pair of water pump pliers, pull back the boot, taking care not to damage it, and remove the wiper arm from the crank arm pivot as shown in the illustration.

    NOTICE:
    Do not damage the pivot.

  1. E156196
    Using a T30 "TORX" socket, remove the 2 screws and wiper motor.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →