REMOVAL
Removal / installation · Vehicles built from Sep 2011
| 1.
REMOVE FRONT FENDER MUDGUARD LH
|
 |
Remove the clip.
Using a T30 "TORX" socket, remove the 4 screws and mudguard.
| 2.
REMOVE SIDE STEP ASSEMBLY LH
|
 |
Remove the 6 bolts and side step.


| 3.
REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY LH
|
 |
Remove the 8 side mudguard retainers and screw.
Detach the 10 clips and remove the rocker panel moulding.


| 4.
REMOVE FRONT FENDER LINER LH
|
 |
Remove the 2 screws.
Using a T30 "TORX" socket, remove the 2 screws.
Using a clip remover, remove the 2 grommets, 12 clips and fender liner.


| 5.
DRAIN WASHER FLUID
|
 |
- Remove the washer hose from the windshield washer motor and pump, and drain the washer fluid.
| 6.
REMOVE WASHER INLET SUB-ASSEMBLY
|
 |
- Using a clip remover, remove the clip and washer inlet.
| 7.
REMOVE WINDSHIELD WASHER JAR ASSEMBLY
|
 |
- Detach the clamp.
Disconnect the 2 connectors.
Disconnect the headlight cleaner hose.
- Remove the 4 bolts. Then remove the windshield washer jar and pump.
| 8.
REMOVE HEADLIGHT CLEANER CONTROL RELAY |
 |
Disconnect the connector.
- Remove the headlight cleaner control relay in the direction shown in the illustration.