2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT HEADLIGHT CLEANER CONTROL RELAY

  1. E186708E06
    w/o Washer Linked Operation:

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (B) - 4 (E)
      Battery voltage is not applied between terminals 3 (IG) and 2 (H)
      10 kΩ or higher
      Battery voltage is applied between terminals 3 (IG) and 2 (H)
      Below 1 Ω (0.8 to 0.9 seconds, then no continuity exists)

      If the result is not as specified, replace the headlight cleaner control relay.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Cleaner Control Relay)

  1. E186708E08
    w/ Washer Linked Operation:

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      6 (B) - 4 (E)
      Battery voltage not applied
      10 kΩ or higher
      Battery positive (+) → Terminal 3 (IG)
      Battery negative (-) → Terminal 4 (E)
      Battery negative (-) → Terminal 5 (FRWA)
      Battery positive (+) → Terminal 3 (IG)
      Battery positive (+) → Terminal 2 (H)
      Battery negative (-) → Terminal 4 (E)
      Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
      Battery positive (+) → Terminal 3 (IG)
      Battery positive (+) → Terminal 1 (HDLO)
      Battery negative (-) → Terminal 4 (E)
      Battery negative (-) → Terminal 5 (FRWA)

      If the result is not as specified, replace the headlight cleaner control relay.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Cleaner Control Relay)

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)REMOVAL (from Sep 2011) →