2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


INSPECT WASHER NOZZLE SUB-ASSEMBLY

  1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the area shown in the illustration.

    If the result is not as specified, replace the washer nozzle.

    E156185E01

    Standard Measurement:
    Area
    Specified Condition
    A
    253.2 mm (9.97 in.)
    B
    41.4 mm (1.63 in.)
    C
    192.9 mm (7.59 in.)
    D
    444.0 mm (17.48 in.)

← COMPONENTS (from Sep 2011)REMOVAL (Sep 2011 – Dec 2011) →