REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
REMOVE UPPER RADIATOR SUPPORT SEAL
|
 |
Remove the 7 clips and radiator support seal.


| 2.
REMOVE FRONT FENDER MAIN SEAL LH (for LHD) |
 |
- Using a screwdriver, detach the 3 clips and remove the fender main seal.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE FRONT FENDER MAIN SEAL RH (for RHD) |
 |
- Using a screwdriver, detach the 3 clips and remove the fender main seal.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE RADIATOR GRILLE ASSEMBLY
|
 |
Put protective tape around the radiator grille.
Remove the 3 screws.
Detach the 2 clips and 8 claws, and remove the radiator grille.
| 5.
REMOVE HOOD LOCK CONTROL CABLE COVER |
 |
- Remove the 3 screws.
Detach the claw and remove the cable cover.
| 6.
REMOVE HOOD LOCK NUT CAP |
 |
- Using a screwdriver, remove the hood lock nut cap as shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
| 7.
REMOVE HOOD LOCK ASSEMBLY |
 |
- Remove the 2 bolts and nut.
Remove the hood lock.
Disconnect the connector.
- Disconnect the hood lock control cable.
| 8.
REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
 |
- Detach the 2 claws.
Disconnect the hood lock control cable and remove the hood lock lever.
| 9.
REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD) |
 |


Using a screwdriver, disconnect the clamps shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Pull the cable from the engine room and remove it.
| 10.
REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD) |
 |


Using a screwdriver, disconnect the clamps shown in the illustration.
- HINT:
- Tape the screwdriver tip before use.
Pull the cable from the engine room and remove it.