2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REMOVE UPPER RADIATOR SUPPORT SEAL

  1. Remove the 7 clips and radiator support seal.

    B180890E02


2. REMOVE FRONT FENDER MAIN SEAL LH (for LHD)

  1. B181061
    Using a screwdriver, detach the 3 clips and remove the fender main seal.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE FRONT FENDER MAIN SEAL RH (for RHD)

  1. B182558
    Using a screwdriver, detach the 3 clips and remove the fender main seal.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY (w/ Winch)

  1. B302213
    Detach the 2 claws.

  1. Detach the 3 guides and remove front bumper winch cover sub-assembly.


5. REMOVE RADIATOR GRILLE ASSEMBLY

  1. B302174E01
    Put protective tape around the radiator grille assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 3 screws.

  1. Detach the 2 clips and 8 claws, and remove the radiator grille assembly.

  1. w/ Wide View Front Monitor System:

    1. Disconnect the connector.


6. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

  1. E239944
    Disconnect the sensor connector.

  1. Remove the 3 bolts and sensor.


7. REMOVE HOOD LOCK CONTROL CABLE COVER

  1. B188474E01
    Remove the 3 screws.

  1. Detach the claw and remove the cable cover.


8. REMOVE HOOD LOCK NUT CAP

  1. B188477E01
    Using a screwdriver, remove the hood lock nut cap as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.


9. REMOVE HOOD LOCK ASSEMBLY

  1. B188475E01
    Remove the 2 bolts and nut.

  1. Remove the hood lock.

  1. Disconnect the connector.

  1. B188476E01
    Disconnect the hood lock control cable.


10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

  1. B310743
    Detach the 2 claws.

  1. Disconnect the hood lock control cable and remove the hood lock lever.


11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)

B309368
  1. Using a screwdriver, disconnect the clamps shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the cable from the engine room and remove it.


12. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)

B309369
  1. Using a screwdriver, disconnect the clamps shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. Pull the cable from the engine room and remove it.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →