2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  1. B180820
    Detach the clip and claw, and remove the front door lower frame bracket garnish LH.


4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

  1. B180816E01
    Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


5. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH

B180817
  1. Using a moulding remover, detach the 5 claws.

  1. Disconnect the connector and remove the armrest base panel.


6. REMOVE DOOR ASSIST GRIP COVER LH

  1. B180819
    Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.


7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B310800E01
    Remove the 3 screws.

  1. Remove the 13 clips.

  1. Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

    HINT:
    Make sure that the pin labeled A in the illustration is detached from the door panel.

  1. Disconnect the connector.

  1. B180822
    Disconnect the 2 cables from the front door inside handle sub-assembly LH.


8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
  1. Disconnect the speaker connector.

  1. B181519
    Remove the 4 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →