2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

  1. B180907E01
    Using a screwdriver, detach the 4 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective tape


3. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

  1. B180908
    Using a moulding remover, detach the 7 claws.

  1. Disconnect the connector and remove the armrest base panel.


4. REMOVE DOOR ASSIST GRIP COVER LH

  1. B183924
    Attach the 9 claws to install the door assist grip cover to the door trim panel.


5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
  1. Connect the connector.

  1. B183925
    Connect the rear door lock remote control cable and rear door inside locking cable to the rear door inside handle sub-assembly.

  1. B180912
    Attach the 4 claws and 9 clips to install the rear door trim board sub-assembly.

  1. Install the 3 screws.


6. REMOVE REAR SPEAKER SET

  1. B181520
    Disconnect the speaker connector.

  1. Remove the 3 screws.

  1. Detach the claw and remove the speaker.

    NOTICE:
    Do not touch the cone part of the speaker.


7. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)

  1. B181521
    Disconnect the connector.

  1. Detach the clamp.

  1. Remove the 2 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →