2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

  1. B180907E01
    Using a screwdriver, detach the 4 claws and remove the rear door inside handle bezel LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

  1. B180908
    Using a moulding remover, detach the 7 claws.

  1. Disconnect the connector and remove the armrest base panel.


5. REMOVE DOOR ASSIST GRIP COVER LH

  1. B180910
    Using a moulding remover, detach the 9 claws and remove the assist grip cover LH.


6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  1. B310802E01
    Remove the 3 screws.

  1. Remove the 9 clips.

  1. Remove the rear inner door glass weatherstrip LH together with the rear door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

    HINT:
    Make sure that the pin labeled A in the illustration is detached from the door panel.

  1. Disconnect the connector and remove the rear door trim board sub-assembly LH.

  1. B180913
    Disconnect the 2 cables from the rear door inside handle sub-assembly LH.


7. REMOVE REAR SPEAKER SET

  1. B181520
    Disconnect the speaker connector.

  1. Remove the 3 screws.

  1. Detach the claw and remove the speaker.

    NOTICE:
    Do not touch the cone part of the speaker.


8. REMOVE REAR NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)

  1. B181521
    Disconnect the connector.

  1. Detach the clamp.

  1. Remove the 2 screws and speaker.

    NOTICE:
    Do not touch the cone part of the speaker.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →