2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


CHECK OIL QUALITY
  1. Check the engine oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the engine oil and oil filter element (Click here).


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The engine oil level should be between the dipstick low level mark and full level mark.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


CHECK ENGINE OIL PRESSURE
  1. Remove the oil pressure sender gauge (Click here).

  1. A170337
    Install an oil pressure sender gauge with an adapter.

  1. Warm up the engine.

  1. Measure the engine oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idle
    50 kPa (0.5 kgf/cm2, 7.3 psi) or more
    2500 rpm
    230 kPa (2.3 kgf/cm2, 33 psi) or more

    If the pressure is not as specified, check the oil pump.

  1. Remove the oil pressure gauge and adapter.

  1. Install the oil pressure sender gauge (Click here).

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →