2011-2013 Land Cruiser · Service Manual Power Source / Network

U1100 Lost Communication with Seat Belt Control ECU

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U1100
There is no communication from the seat belt control ECU.
  1. Power source circuit of seat belt control ECU
  2. Seat belt control ECU
  3. Seat belt control ECU branch wire or connector

HINT:
For vehicles with the pre-crash safety system only.


WIRING DIAGRAM

C150433E07

INSPECTION PROCEDURE


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (SEAT BELT CONTROL ECU BRANCH WIRE)

  1. C150943E04
    Disconnect the E42 seat belt control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E42-1 (CANH) - E42-2 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE SEAT BELT CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (SEAT BELT CONTROL ECU - BATTERY AND BODY GROUND)
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. C150944E04
    Disconnect the E41 and E42 seat belt control ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E41-8 (PGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E41-7 (+B) - Body ground
    Always
    11 to 14 V
    E42-8 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SEAT BELT CONTROL ECU (Click here)


← U1002 (CAN No. 2 BUS) Lost Communication with Gateway Module (Network Gateway ECU) (from Jan 2012)U1100 Lost Communication with Seat Belt Control ECU (from Jan 2012) →