2011-2013 Land Cruiser · Service Manual Vehicle Interior

U0129 Lost Communication with Brake System Control Module

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The combination meter communicates with the skid control ECU via the CAN line.
DTC Code
DTC Detection Condition
Trouble Area
U0129
When 15 seconds have elapsed after the engine is started and IG voltage is 10.5 V or more while no communication with the skid control ECU continues for 3 seconds or more (no communication with the ECM or skid control ECU continues for 60 seconds or more).
CAN communication system

WIRING DIAGRAM

E140490E12

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Check for DTCs and note any codes that are output (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs (Click here).

    Result 
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system (for LHD) DTC is output
    B
    CAN communication system (for RHD) DTC is output
    C

    HINT:
    If CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0129 first.



B
Go to CAN COMMUNICATION SYSTEM (Click here)

C
Go to CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← U0100 Lost Communication with ECM / PCM "A" (from Jan 2012)U0129 Lost Communication with Brake System Control Module (from Jan 2012) →