TERMINALS OF ECU
System information · Vehicles built from Jan 2012
| CHECK HEATED STEERING WHEEL CONTROLLER |
- HINT:
- Inspect the connectors from the back side while the connectors are connected.


Measure the voltage or resistance according to the value(s) in the table below.
Terminal No. (Symbol)
Terminal Description
Condition
Specified Condition
A-1 (CCU) - Body ground
LED output signal
Ignition switch ON, Steering heater switch on
Below 3 V
A-2 (CCV) - Body ground
Steering heater switch input signal
Ignition switch ON, Steering heater switch pressed and held
11 to 14 V
A-3 (CCX) - Body ground
Ground
Always
Below 1 Ω
A-4 (CCW) - Body ground
IG power supply
Ignition switch ON
11 to 14 V
B-1 (TH1) - Body ground
Thermistor input signal
Ignition switch ON, Steering heater switch on at 0 to 40°C (32 to 104°F)
1.5 to 4.5 V*1
B-2 (TH2) - Body ground
Thermistor ground
Ignition switch ON, Steering heater switch on
Below 1 V
B-3 (SH2) - Body ground
Heater output signal
Ignition switch ON, Steering heater switch on
11 to 14 V*2
B-4 (SH1) - Body ground
Heater ground
Ignition switch ON, Steering heater switch on
Below 1 V
- HINT:
- *1: When ambient temperature is 0 to 40°C (32 to 104°F).
- *2: The current to the heater turns ON/OFF depending on the temperature of the thermistor. As a result, it may take several minutes before a voltage value is output.
- *1: When ambient temperature is 0 to 40°C (32 to 104°F).