Wiper and Washer Switch Circuit
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit provides power to operate the windshield wiper switch. The manual operation signals are sent to the windshield wiper ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (ECU-IG No. 1) |
Remove the ECU-IG No. 1 fuse from the cowl side junction block LH.
Measure the resistance according to the value in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
ECU-IG No. 1 fuse
Always
Below 1 Ω
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (WINDSHIELD WIPER SWITCH) |
Check the Data List for proper functioning of the windshield wiper switch.
Combination Switch Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
F Wiper LO SW
Front wiper LO switch / ON or OFF
ON: Front wiper switch in LO
OFF: Front wiper switch not in LO
-
F Wiper HI SW
Front wiper HI switch / ON or OFF
ON: Front wiper switch in HI
OFF: Front wiper switch not in HI
-
F Wiper AUTO SW
Front wiper AUTO switch / ON or OFF
ON: Front wiper switch in AUTO
OFF: Front wiper switch not in AUTO
-
F Wiper MIST SW
Front wiper MIST switch / ON or OFF
ON: Front wiper switch in MIST
OFF: Front wiper switch not in MIST
-
F Washer SW
Front washer switch / ON or OFF
ON: Front washer switch on
OFF: Front washer switch off
-
- OK:
- The display is as specified in the normal condition.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH - BATTERY AND BODY GROUND) |
Disconnect the E16 switch connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
for LH Side Tester Connection
Switch Condition
Specified Condition
E16-2 (+B) - Body ground
Engine switch on (IG)
11 to 14 V
E16-2 (+B) - Body ground
Engine switch off
Below 1 V
for RH Side Tester Connection
Switch Condition
Specified Condition
E16-3 (+B) - Body ground
Engine switch on (IG)
11 to 14 V
E16-3 (B) - Body ground
Engine switch off
Below 1 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LH Side Tester Connection
Condition
Specified Condition
E16-10 (E) - Body ground
Always
Below 1 Ω
for RH Side Tester Connection
Condition
Specified Condition
E16-5 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
