2011-2013 Land Cruiser · Service Manual Vehicle Exterior

Wiper Switch (HI Speed) Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The windshield wiper ECU receives the HI position signal of the wiper switch to operate the wiper motor at HI speed. Even if the ECU malfunctions, its circuit structure enables it to operate the wiper in HI operation mode.

WIRING DIAGRAM

E158172E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (WINDSHIELD WIPER SWITCH ASSEMBLY)
  1. Check the Data List for proper functioning of the windshield wiper switch.

    Combination Switch 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    F Wiper HI Switch
    Front wiper HI switch / ON or OFF
    ON: Front wiper switch in HI position
    OFF: Wiper switch not in HI position
    -

    OK:
    Wiper switch operates.



NG
Go to step 2
OK

REPLACE WINDSHIELD WIPER ECU (Click here)

2. INSPECT WINDSHIELD WIPER SWITCH
E158822E01
  1. Disconnect or remove the switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side 
    Tester Connection
    Switch Condition
    Specified Condition
    4 (+2) - 2 (+B)
    Wiper switch in HI position
    Below 1 Ω
    4 (+2) - 2 (+B)
    Wiper switch not in HI position
    10 kΩ or higher
    for RH Side 
    Tester Connection
    Switch Condition
    Specified Condition
    1 (+2) - 3 (+B)
    Wiper switch in HI position
    Below 1 Ω
    1 (+2) - 3 (+B)
    Wiper switch not in HI position
    10 kΩ or higher



NG
REPLACE WINDSHIELD WIPER SWITCH (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH - WINDSHIELD WIPER ECU)

  1. E157246E01
    Disconnect the E16 switch connector.

  1. Disconnect the E83 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side 
    Tester Connection
    Condition
    Specified Condition
    E16-4 (+2) - E83-9 (2S)
    Always
    Below 1 Ω
    E16-2 (+B) - E83-6 (ES)
    E83-9 (2S) - Body ground
    Always
    10 kΩ or higher
    for RH Side 
    Tester Connection
    Condition
    Specified Condition
    E16-1 (+2) - E83-9 (2S)
    Always
    Below 1 Ω
    E16-3 (+B) - E83-6 (ES)
    E83-9 (2S) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE WINDSHIELD WIPER ECU (Click here)


← Front Wiper Motor Circuit (from Jan 2012)Wiper Switch (HI Speed) Circuit (from Jan 2012) →