Front Wiper Motor Circuit
Circuit diagnosis · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
The windshield wiper ECU controls the wiper motor.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (FRONT WIPER MOTOR) |
Select the Active Test, use the intelligent tester to generate a control command, and then check the front wiper motor.
- NOTICE:
- When a Body No. 5 (windshield wiper ECU) related front wiper switch is on, Active Test items related to the front wiper switch are prohibited (double operation prohibition). Check that the front wiper switches are off before performing Active Test.
Body No. 5 Item
Test Details
Control Range
Diagnostic Note
Wiper Mot (HI)
Wiper motor HI operation
ON / OFF
-
Wiper Mot (LO)
Wiper motor LO operation
ON / OFF
-
- OK:
- Front wiper motor operates.
|
|
||||
| OK | ||
| ||
| 2. INSPECT FRONT WIPER MOTOR |
Remove the front wiper motor (Click here).

Apply battery voltage to the front wiper motor and check the speed of the front wiper motor.
- OK:
for LHD Measurement Condition
Specified Condition
Battery positive (+) → Terminal 1 (+1)
Battery negative (-) → Terminal 5 (E)
Motor operates at low speed
Battery positive (+) → Terminal 4 (+2)
Battery negative (-) → Terminal 5 (E)
Motor operates at high speed
for RHD Measurement Condition
Specified Condition
Battery positive (+) → Terminal 5 (+1)
Battery negative (-) → Terminal 4 (E)
Motor operates at low speed
Battery positive (+) → Terminal 3 (+2)
Battery negative (-) → Terminal 4 (E)
Motor operates at high speed
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (FRONT WIPER MOTOR - WINDSHIELD WIPER ECU AND BODY GROUND) |
Disconnect the A22 motor connector.

Disconnect the E83 ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection
Condition
Specified Condition
A22-2 (B) - E83-8 (WIG)
Always
Below 1 Ω
A22-1 (+1) - E83-1 (+1)
A22-4 (+2) - E83-2 (+2)
A22-3 (+S) - E83-7 (+SM)
A22-5 (E) - Body ground
A22-3 (+S) - Body ground
Always
10 kΩ or higher
A22-2 (B) - Body ground
A22-4 (+2) - Body ground
A22-1 (+1) - Body ground
for RHD Tester Connection
Condition
Specified Condition
A22-2 (B) - E83-8 (WIG)
Always
Below 1 Ω
A22-5 (+1) - E83-1 (+1)
A22-3 (+2) - E83-2 (+2)
A22-1 (+S) - E83-7 (+SM)
A22-4 (E) - Body ground
A22-1 (+S) - Body ground
Always
10 kΩ or higher
A22-2 (B) - Body ground
A22-3 (+2) - Body ground
A22-5 (+1) - Body ground
|
|
||||
| OK | ||
| ||
