2011-2013 Land Cruiser · Service Manual Power Source / Network

U1111 Lost Communication with Body No. 5 Module

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U1111
There is no communication from the windshield wiper ECU.
  1. Power source circuit of windshield wiper ECU
  2. Windshield wiper ECU
  3. Windshield wiper ECU main wire or connector

HINT:
For vehicles with the rain sensor only.


WIRING DIAGRAM

C177598E01

INSPECTION PROCEDURE


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (WINDSHIELD WIPER ECU BRANCH WIRE)

  1. C176426E01
    Disconnect the E85 windshield wiper ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E85-6 (CANH) - E85-5 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE WINDSHIELD WIPER ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER ECU - BATTERY AND BODY GROUND)
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. C176427E02
    Disconnect the E83 and E85 windshield wiper ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E85-10 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E83-5 (IG1I) - Body ground
    Ignition switch ON
    11 to 14 V
    E83-8 (WIG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE WINDSHIELD WIPER ECU (Click here)


← U1110 Lost Communication with Clearance Sonar Module (from Jan 2012)U1111 Lost Communication with Body No. 5 Module (from Jan 2012) →