INSTALLATION
Removal / installation · Vehicles built from Sep 2011
| 1. INSTALL CRANKSHAFT POSITION SENSOR |
![]() ![]() |
Apply a light coat of engine oil to the O-ring.
- NOTICE:
- When reusing the sensor, inspect the O-ring.
- If the O-ring has scratches or cuts, replace the sensor.
Install the sensor with the bolt.

- Torque:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
Connect the sensor wire harness clamp.
| 2. INSTALL COOLER COMPRESSOR ASSEMBLY |
Install the cooler compressor (Click here).

