2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sens. No. 1 Volt % and Accel Sens. No. 2 Volt %.

  1. Read the value displayed on the GTS.

    Standard Value:
    Tester Display
    Condition
    Specified Condition
    Accel Sens. No. 1 Volt %
    Released
    10 to 22%
    Depressed
    52 to 90%
    Accel Sens. No. 2 Volt %
    Released
    24 to 40%
    Depressed
    68 to 99%

    If the result is not as specified, check the accelerator pedal, wire harness or ECM.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →